- Can you solder over old solder?
- What metal Cannot be soldered?
- What can you use instead of soldering?
- What can I use instead of flux for soldering?
- What is flux made of?
- Can you solder copper without flux?
- Why is soldering so hard?
- Can you use Vaseline as flux?
- What causes solder to ball up?
- Do I need flux to solder?
- Can I solder without flux?
Can you solder over old solder?
Just heat the joint up with your torch, once the solder starts to melt use Channel locks to pull the fittings apart.
Once the joint is apart, wipe as much old solder off as you can with a rag.
Now you can start over.
Clean, Flux, solder..
What metal Cannot be soldered?
Many different types of metals can be brazed. Copper, and copper based materials like brass and bronze, are typically brazed with copper phosphorus silver alloys also known as American Welding Society (AWS) BCuP filler metals.
What can you use instead of soldering?
Wire-wrapping is a substitute for soldering but wire-wrap supplies can get very expensive unless you buy in very large volumes or happen to find a surplus deal. You could also crimp the wires together. There are terminals called butt splices.
What can I use instead of flux for soldering?
A: The classical fluxes were wood rosin and acid solutions – both intended to protect even etch the top surface when it gets hot and is likely to oxidize. Instead, you can place a puddle of solder on one (horizontal) surface, and with a pen knife blade, scratch the metal under the blob.
What is flux made of?
Common fluxes are: ammonium chloride or resin acids (contained in rosin) for soldering copper and tin; hydrochloric acid and zinc chloride for soldering galvanized iron (and other zinc surfaces); and borax for brazing, braze-welding ferrous metals, and forge welding.
Can you solder copper without flux?
Flux is a chemical which helps you solder. Flux prevents the copper from oxidizing as you heat the copper with the torch. … You can solder without flux, but it is really difficult! Flux is applied to both the pipe and the fitting with a handy miniature paint brush.
Why is soldering so hard?
Soldering is a process somewhat like gluing, in that the solder has to form a tight bond between the parts. Just as clean parts glue better, they also solder better. Any mud, blood, beer, grease, oil, or especially oxidation will make the joint difficult or impossible to solder well.
Can you use Vaseline as flux?
The answer is yes. Using petroleum jelly as a soldering flux is an effective soldering flux alternative.
What causes solder to ball up?
Solder balls are caused by gassing and spitting of the flux on the surface of the wave or by solder literally bouncing back from the solder wave. This is caused by excessive back flow in air or too high a drop in nitrogen environments.
Do I need flux to solder?
Flux core solder has flux in the center of the solder wire. Additional flux is unnecessary for most applications, but using additional flux still may make the solder easier to work with for some tasks. When selecting flux core solder, it is important to use rosin core solder for electrical applications.
Can I solder without flux?
It’s ok, if you can do it, but it’s very difficult to solder without flux. The flux breaks down the oxide layers on the metal surfaces and allows the solder to “wet” them. If it doesn’t wet, it doesn’t make a connection. … It’s normally always necessary to use flux when you solder.